Today, one HP200 bauxite hydrocone crusher with the productivity of 3000 tons per day has been packaged already and will be shipped to Brazil.
I am Ehsan Ullah Prince from Gujrat Punjab Pakistan, I have a sand Maker, I want to know if you can give me some notes for the Maintenance of sand Maker?
New-type sand maker is manufactured with the introduction of advanced technologies from Europe.
FTM jaw crusher liner is composed of the liner body, the hollow lightening hole in backside, anti-loose fixture block hole, reinforcing rib, anti-loose fixed block, lifting hole, etc. Each parts strengths of FTM jaw crusher liner will be presented below.
Common senses on lubrication system of symons crushers,1. Lubricating oil enters the symons crushers in two ways.2. Keep the lubricating oil warm in winter.3. Lubricating oil temperature shall not be higher than 60 ℃.4. Control oil pressure.5. The limit of water which entering the heat exchanger.6. Conduit cleaning of the lubrication system.7. Oil level in the oil receiver.8. Keep the filter clean.9. Inspection frequency.
Contrast of cs cone crusher and hp cone crusher in operation,1.Contrast on the adjusting mode of their discharge ports.2.Contrast of their overload and over-iron protection performance.3.Contrast on whether CS cone crusher and hp cone crusher can realize the load start.4.Contrast on whether CS cone crusher and hp cone crusher can work in no-load condition.Contrast on whether feeding materials must be full of the crushing cavity during production process.